Standard Cross Grinding Wheel
- 60 Grit
- 6″ x 1″ x 3/4″
- Works great for profiling and rockering
We sell the highest quality, best balanced wheels in the industry. Guaranteed or your money back!
Cross grinding should only be done when there are nicks and gouges that can not be removed by the finishing wheel.
Cross grinding should not be done to remove a bad sharpen, rust on the blades, or to change hollows.
Normally 2 passes is sufficient, and you must be careful to apply even pressure and not round over the toe and heel.
Always perform the ring test before installing a grinding wheel. Put your finger through the hole and suspend the wheel. Then tap the wheel with your knuckle or a screwdriver. If it rings like a bell it is good to use. If you hear a “thud” it is cracked and must be discarded.